Command Line Interface
4-86
4
• You can specify three authentication methods in a single command to
indicate the authentication sequence. For example, if you enter
“authentication enable radius tacacs local,” the user name and password
on the RADIUS server is verified first. If the RADIUS server is not available,
then authentication is attempted on the TACACS+ server. If the TACACS+
server is not available, the local user name and password is checked.
Example
Related Commands
enable password (4-27)
RADIUS Client
Remote Authentication Dial-in User Service (RADIUS) is a logon authentication
protocol that uses software running on a central server to control access to
RADIUS-aware devices on the network. An authentication server contains a
database of multiple user name/password pairs with associated privilege levels for
each user or group that require management access to a switch.
Console(config)#authentication enable radius
Console(config)#
Table 4-31. RADIUS Client Commands
Command Function Mode Page
radius-server host Specifies the RADIUS server GC 4-87
radius-server port Sets the RADIUS server network port GC 4-88
radius-server key Sets the RADIUS encryption key GC 4-88
radius-server retransmit Sets the number of retries GC 4-89
radius-server timeout Sets the interval between sending authentication requests GC 4-89
radius-server service-type Sends the Filter ID to the RADIUS server during
authentication
GC 4-90
show radius-server Shows the current RADIUS settings PE 4-92
To Next Page
Loading...
Need help?
General