Command Line Interface
4-28
4
IP Filter Commands
management
This command specifies the client IP addresses that are allowed management
access to the switch through various protocols. Use the no form to restore the
default setting.
Syntax
[no] management {all-client | http-client | snmp-client | telnet-client}
start-address [end-address]
• all-client - Adds IP address(es) to the SNMP, web and Telnet groups.
• http-client - Adds IP address(es) to the web group.
• snmp-client - Adds IP address(es) to the SNMP group.
• telnet-client - Adds IP address(es) to the Telnet group.
- start-address - A single IP address, or the starting address of a range.
- end-address - The end address of a range.
Default Setting
All addresses
Command Mode
Global Configuration
Command Usage
• If anyone tries to access a management interface on the switch from an
invalid address, the switch will reject the connection, enter an event
message in the system log, and send a trap message to the trap manager.
• IP address can be configured for SNMP, web and Telnet access
respectively. Each of these groups can include up to five different sets of
addresses, either individual addresses or address ranges.
• When entering addresses for the same group (i.e., SNMP, web or Telnet),
the switch will not accept overlapping address ranges. When entering
addresses for different groups, the switch will accept overlapping address
ranges.
• You cannot delete an individual address from a specified range. You must
delete the entire range, and reenter the addresses.
• You can delete an address range just by specifying the start address, or by
specifying both the start address and end address.
Table 4-10. IP Filter Commands
Command Function Mode Page
management Configures IP addresses that are allowed management access GC 4-28
show management Displays the switch to be monitored or configured from a
browser
PE 4-29
To Next Page
Loading...
Need help?
General