Enterasys Matrix-V V2H124-24

Access Control List Commands
4-133
4
Related Commands
show mac access-list (4-128)
show mac access-group
This command shows the ports assigned to MAC ACLs.
Command Mode
Privileged Exec
Example
Related Commands
mac access-group (4-132)
map access-list mac
This command sets the output queue for packets matching an ACL rule. The
specified CoS value is only used to map the matching packet to an output queue; it
is not written to the packet itself. Use the no form to remove the CoS mapping.
Syntax
[no] map access-list mac acl_name cos cos-value
• acl_name – Name of the ACL. (Maximum length: 16 characters)
• cos-value – CoS value. (Range: 0-7)
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
• You must configure an ACL mask before you can map CoS values to the
rule.
• A packet matching a rule within the specified ACL is mapped to one of the
output queues as shown below.
Console#show mac access-group
Interface ethernet 1/5
MAC access-list M5 out
Console#
Table 4-41. Mapping CoS Values to MAC ACL Rules
Queue 0 1 2 3
Priority 1,2 3 4,5 6,7