Command Line Interface
4-124
4
show map access-list ip
This command shows the CoS value mapped to an IP ACL for the current interface.
(The CoS value determines the output queue for packets matching an ACL rule.)
Syntax
show map access-list ip [interface]
interface
- ethernet unit/port
- unit - This is device 1.
- port - Port number.
Command Mode
Privileged Exec
Example
Related Commands
map access-list ip (4-123)
match access-list ip
This command changes the IEEE 802.1p priority, IP Precedence, or DSCP Priority
of a frame matching the defined ACL rule. (This feature is commonly referred to as
ACL packet marking.) Use the no form to remove the ACL marker.
Syntax
match access-list ip acl_name
[set
priority priority] {set tos tos_value | set dscp dscp_value}
no match access-list ip acl_name
• acl_name – Name of the ACL. (Maximum length: 16 characters)
• priority – Class of Service value in the IEEE 802.1p priority tag.
(Range:
0-7; 7 is the highest priority)
• tos_value – IP Precedence value. (Range: 0-7)
• dscp_value – Differentiated Services Code Point value. (Range: 0-63)
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Console#show map access-list ip
Access-list to COS of Eth 1/4
Access-list ALS1 cos 0
Console#
To Next Page
Loading...
Need help?
General