Configuring the Switch
3-88
3
- Sym - Transmits and receives pause frames for flow control
- FC - Supports flow control
• Broadcast storm – Shows if broadcast storm control is enabled or disabled.
• Broadcast storm limit – Shows the broadcast storm threshold. (500 - 262143
packets per second)
• Flow control – Shows if flow control is enabled or disabled.
• LACP – Shows if LACP is enabled or disabled.
• Port Security – Shows if port security is enabled or disabled.
• Max MAC count – Shows the maximum number of MAC address that can be
learned by a port. (0 - 1024 addresses)
• Port security action – Shows the response to take when a security violation is
detected. (shutdown, trap, trap-and-shutdown)
Current status:
• Link Status – Indicates if the link is up or down.
• Operation speed-duplex – Shows the current speed and duplex mode.
• Flow control type – Indicates the type of flow control currently in use.
(IEEE 802.3x, Back-Pressure or none)
CLI – This example shows the connection status for Port 25 on the V2X124-24FX.
Console#show interfaces status ethernet 1/25 4-158
Information of Eth 1/25
Basic information:
Port type: FxSc multi
Mac address: 00-01-F4-73-7E-39
Configuration:
Name:
Port admin: Up
Speed-duplex: 100full
Capabilities: 100full
Broadcast storm: Enabled
Broadcast storm limit: 500 packets/second
Flow control: Enabled
LACP: Disabled
Port security: Disabled
Max MAC count: 0
Port security action: None
Current status:
Link status: Down
Operation speed-duplex: 1000full
Flow control type: Dot3X
Console#
To Next Page
Loading...
Need help?
General