Flash/File Commands
4-67
4
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• The system prompts for data required to complete the copy command.
• The destination file name should not contain slashes (\ or /), the leading letter
of the file name should not be a period (.), and the maximum length for file
names on the TFTP server is 127 characters or 31 characters for files on the
switch. (Valid characters: A-Z, a-z, 0-9, “.”, “-”, “_”)
• Due to the size limit of the flash memory, the switch supports only two
operation code files.
• The maximum number of user-defined configuration files depends on
available memory.
• You can use “Factory_Default_Config.cfg” as the source to copy from the
factory default configuration file, but you cannot use it as the destination.
• To replace the startup configuration, you must use startup-config as the
destination.
• For information on specifying an https-certificate, see “Replacing the Default
Secure-site Certificate” on page 3-58. For information on configuring the
switch to
use HTTPS/SSL for a secure connection, see “ip http secure-server”
on page 4-31.
• When updating the PoE controller, first copy the PD controller file from a
TFTP server to the switch's file system (copy tftp file, and select
PD_Controller), and then copy this file to the controller (copy file controller,
and select P).
• When specifying the file type “PD_Controller” or “P” for copy operations, file
types other than PoE controller may be downloaded, but will not adversely
affect the system.
Example
The following example shows how to upload the configuration settings to a file on
the TFTP server:
Console#copy file tftp
Choose file type:
1. config: 2. opcode 3. PD_Controller: <1-3>: 2
Source file name: startup
TFTP server ip address: 10.1.0.99
Destination file name: startup.01
TFTP completed.
Success.
Console#
To Next Page
Loading...
Need help?
General