Interface Commands
4-151
4
interface
Use this command to configure an interface type and enter interface configuration
mode. Use the no form to remove a trunk.
Syntax
interface interface
no interface port-channel channel-id
interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-32)
• vlan vlan-id (Range: 1-4093)
Default Setting
None
Command Mode
Global Configuration
Example
To specify the port 25, enter the following command:
description
Use this command to add a description to an interface. Use the no form to remove
the description.
Syntax
description string
no description
string - Comment or a description to help you remember what is attached
to this interface. (Range: 1-64 characters)
clear counters Clears the statistics on a given interface PE 4-157
show interfaces status Displays status for the specified interface NE, PE 4-158
show interfaces
counters
Displays statistics for the specified interfaces NE, PE 4-159
show interfaces
switchport
Displays the administrative and operational status of an interface NE, PE 4-160
Console(config)#interface ethernet 1/25
Console(config-if)#
Table 4-48. Interface Commands (Continued)
Command Function Mode Page
To Next Page
Loading...
Need help?
General