Configuring the Switch
3-22
3
CLI – Enter the IP address of the TFTP server, specify the source file on the server,
set the startup file name on the switch, and then restart the switch.
To select another configuration file as the start-up configuration, use the boot
system comand and then restart the switch.
This example shows how to download a PoE controller file from a TFTP server.
Note: It is possible to download a PoE Controller file to a non-PoE switch, doing so will
not cause any adverse effects.
This example shows how to copy a PoE controller file from another unit in the stack.
Console#copy tftp startup-config 4-66
TFTP server ip address: 192.168.1.19
Source configuration file name: config-1
Startup configuration file name [] : startup
\Write to FLASH Programming.
-Write to FLASH finish.
Success.
Console#reload
Console(config)#boot system config: startup-new 4-71
Console(config)#exit
Console#reload 4-22
Console#copy tftp file 4-66
TFTP server IP address: 10.3.4.50
Choose file type:
1. config: 2. opcode 3. PD_Controller: <1-3>: 3
Source file name: 7012_007.s19
Destination file name: P-test
Write to FLASH Programming.
Write to FLASH finish.
Success.
Console#
Console#copy file controller 4-66
Unit <1-2>: 2
Choose controller type:
1. P: 2. VDSL: 3. TBD <1-3>: 1
Source file name: P-test
Software downloading in progress, please wait...
Unit 1 done
Console#
To Next Page
Loading...
Need help?
General