⚫ Be sure to connect the cables properly. Do not allow unnecessary strain on the cables. (Do not put heavy objects on the
cables. Do not bend or pull the cables forcibly.) The unnecessary strain on the cables may result in damage to the cables,
disconnection, and/or contact failure. Damaged cables, disconnection, or contact failure is extremely hazardous and
may result in electric shock and/or improper function of the robot system.
⚫ When operating maintenance of Manipulator, secure about 500 mm of empty space around the Manipulator.
⚫ Carefully use alcohol, liquid gasket, and adhesive following respective instructions and instructions below. Careless use
of alcohol, liquid gasket, or adhesive may cause a fire and/or safety problem.
Never put alcohol, liquid gasket, or adhesive close to fire.
Use alcohol, liquid gasket, or adhesive while ventilating the room.
Wear protective gear including a mask, protective goggles, and oil-resistant gloves.
If alcohol, liquid gasket, or adhesive gets on your skin, wash the area thoroughly with soap and water.
If alcohol, liquid gasket, or adhesive gets into your eyes or mouth, flush your eyes or wash out your mouth with
clean water thoroughly, and then see a doctor immediately.
⚫ Wear protective gear including a mask, protective goggles, and oil-resistant gloves during grease up. If grease gets into
your eyes, mouth, or on your skin, follow the instructions below.
If grease gets into your eyes
Flush them thoroughly with clean water, and then see a doctor immediately.
If grease gets into your mouth
If swallowed, do not induce vomiting. See a doctor immediately. If grease just gets into your mouth, wash out your
mouth with water thoroughly.
If grease gets on your skin
Wash the area thoroughly with soap and water.
To Next Page
Loading...
