9. Lift the ribbon guide of the ribbon cartridge (i ) and insert it
firmly over the metal pins behind the print head (t ). Make
sure the ribbon is not twisted or creased and that it is in
place behind the print head. Press down the guide until it
clicks into place.
10. Turn the ribbon-tightening knob in the direction of the
arrow to remove any slack in the ribbon as shown above.
Then slide the print head from side to side to make sure
it moves smoothly.
ribbon-tightening
knob
ribbon guide
1-6SU
1-7
L
Sun-G+ Rev.C
A5 size Chapter 1
97/11/14 pass 0
1-10 Setting Up the Printer
To Next Page
Loading...
