To load paper onto the pull tractor, follow these steps:
1. Make sure the printer is turned off, and the printer cover is
removed. Also check that a tractor is installed in the pull
position.
2. Slide the edge guides to the middle of the paper guide.
3. Set the paper release lever to the pull tractor position. Also
set the paper thickness lever to the proper position for your
paper’s thickness.
4. Release the left and right sprockets by pulling the sprocket
lock levers forward.
2-31
2-32a
2
R
Sun-G+ Rev.C
A5 size Chapter 2
97/11/17 pass 3
Printing on Continuous Paper 2-25
To Next Page
Loading...
Need help?
General
