5. Slide the left sprocket to the left margin of the paper using the
scale on the paper guide as a guide. (Printing starts at the
arrow mark.) Then push the lever back to lock it in place.
Note:
See “Paper alignment” and “Printable area” in Appendix C for more
information on the left margin position.
6. Push back the left sprocket lever to lock it in place.
7. Slide the right sprocket to match the width of your paper, but do
not lock it. Move the paper support midway between the two
sprocket units as shown above. Then open both sprocket
covers.
8. Make sure your paper has a clean, straight edge.
2-33a
L
Sun-G+ Rev.C
A5 size Chapter 2
97/11/17 pass 3
2-26 Printing on Continuous Paper
To Next Page
Loading...
Need help?
General
