9. Insert the paper into the front, bottom, or rear paper slot as
described below until it emerges between the platen and
the ribbon guide. Then pull up the paper until the
perforation between the first and second pages is even
with the top of the printer’s ribbon.
10. Fit four holes of the paper over the tractor pins on both
sprockets. Then close the sprocket covers.
11. Slide the right sprocket to remove any slack in the paper; then
lock it in place by pushing the sprocket lock down.
Before you load paper in the
front slot, remove the front
paper guide. Then load
paper printable side up.
2-34a
Load paper in the bottom slot
printable side up (forward).
2-34b
Before you load paper in the
rear slot, remove the paper
guide. Then load paper in
the rear slot printable side
down.
2-34c
2
R
Sun-G+ Rev.C
A5 size Chapter 2
97/11/17 pass 3
Printing on Continuous Paper 2-27
To Next Page
Loading...
Need help?
General
