To adjust the top-of-form position for continuous paper
loaded on the pull tractor, see the following example:
First mark a point 6.5 mm (0.26 inch) above the paper’s
perforation; then position the paper so that the mark even
with the top edge of the plastic ribbon cover. This gives you an
8.5 mm (0.33 inch) margin on the next page, meaning the
printer starts printing 8.5 mm below the perforation. If you
mark a point 5.5 mm (0.22 inch) above the perforation, you get
a 9.5 mm (0.37 inch) margin on the next page.
6. After you set the top-of-form position, press the
Pause button
to exit micro adjust mode.
(0.26 inch)
(0.33 inch)
new14
2
R
Sun-G+ Rev.C
A5 size Chapter 2
97/11/17 pass 3
Printing on Continuous Paper 2-39
To Next Page
Loading...
Need help?
General
