Epson Stylus CX4900 - Page 137

EPSON Stylus CX4900/CX4905/CX5000/DX5000/DX5050/CX5900/CX6000/DX6000/DX6050 Revision A
DISASSEMBLY/ASSEMBLY Printer Section 137
 External view (2)
Figure 4-15. Removing Printer Mechanism (2)
4. Remove the screws (x6, ) that secure the Printer Mechanism.
5. Disconnect the PS Connector Cable from the connector (CN1) of the Main
Board.
6. Ho
ld up the left side of the Printer Mechanism while releasing the guide pin of
the Front Paper Guide Support from the groove of the PG Lever with a
precision screwdriver (-), and remove whole Printer Mechanism from the
Housing, Lower.
2
3
65
1
4
Printer Mechanism
CN1
Main Board
PS Connector Cable
PG Lever
Guide Pin
Front Paper
Guide Support
Groove
C.B.P. 3x8 F/Zn
(4±1kgfcm)
Tab
Holding Positions
C.B.P. 3x10 F/Zn
(4±1kgfcm)
CR Guide Frame
C A U T I O N
Hold the designated position and lift Printer Mechanism upward
when performing the following step in order to prevent warping of
Main Frame.
W A R N I N G
When installing the Printer Mechanism to the Housing, Lower,
insert the Waste Ink Tube to the Waste Ink Cover and securely
fasten the Waste Ink Tube with the Tube Stopper, or ink may leak
from the Tube.
 When installing the Printer Mechanism to the Housing, Lower,
match the guide pin (x1,
) of the Housing, Lower with the
positioning hole (x1) of the Printer Mechanism.
 Tighten the scre
ws in the order as shown in the figure.
 When
installing the Rear Cover, match the tabs (x2, ) of the
Rear Cover with the notches (x2) of the Housing, Lower.
 When
installing the Waste Ink Tube, insert the tube 54 ± 1 mm
(T.B.D) into the Waste Ink Cover as shown below.
Figure 4-16. Installing Waste Ink Tube
Waste Ink Tube
Tube Stopper
54 ± 1mm
Waste Ink Cover