EPSON Stylus CX4900/CX4905/CX5000/DX5000/DX5050/CX5900/CX6000/DX6000/DX6050 Revision A
PRODUCT DESCRIPTION USB Direct-Print/PictBridge Functions 48
1.8.3.2 Standard Operations
Standard operations are described below. These operations depend on the DSC.
1. Preparation at the printer
Some settings are required before connecting with the DSC. If your DSC can set
these settings, preparation at the printer is not required.
1. Choose the Paper Type, Paper Size and Layout to the desired setting.
2. Preparation at the DSC
Some operations are necessary before connecting to the printer.
1. Set the DPOF (or select pictures*
2
) if printing multiple picture.
2. Choose the picture when Single picture print and set area to crop if necessary.
3. Choose the Paper Type and Paper Size (and Layout*
2
) if these settings can be
specified from DSC.
3. Start printing
1. Connect the DSC to the printer with a USB cable. The cable that works well
with the DSC is recommended.
2. Start print by operating from the DSC.
3. The Printer print by printing conditions from DSC, if the DSC dose not
designate the printing parameter, the printer prints it by using the printing
condition that is registered to the printer.*
2
When this unit is connected to a DSC that supports the USB DIRECT-PRINT protocol
(Revision 1.0), print settings, image selection, status monitoring, and print start/stop
commands can be controlled from the DSC.*
1
1.8.3.3 Display when DSC is connected
When DSC is connected with the above conditions:
St
ylus CX4900/CX4905/CX5000/DX5000/DX5050: “P” will be displayed with 7
Segment LED.
St
ylus CX5900/CX6000/DX6000/DX6050: “Camera Connected” icon will be
displayed on the LDC and the “Print All” LED will be turned on.
1.8.3.4 Cancel Print
This unit can be canceled from the DSC. The [Stop] button of the printer is also
available.
1.8.3.5 Operations when the Print is Completed
To print from the memory card, disconnect the USB cable after printing is complete.
1.8.3.6 Exclusive Control Specifications for Paper Type, Size, and
Layout
Depending upon the DSC and printer settings, there may be some combinations of
paper type, size, and layout settings that are not supported by this printer. In such a
case, the paper type is given priority; paper size and layout are changed to settings that
will allow printing (the initial settings made on the printer’s operation panel for the
paper type given priority) and the document is printed.
1.8.3.7 Camera direct error executing other processing (error)
(Stylus CX5900/CX6000/DX6000/DX6050 only)
When unsupported equipment are connected during the other processing is executed
(error), the camera direct error is displayed after other processing execution (error).
When the unsupported equipment is connected and other processing ends, it doesn’t
become a camera direct mode and the camera direct error is not displayed.
To Next Page
Loading...
Need help?
General