EPSON Stylus CX4900/CX4905/CX5000/DX5000/DX5050/CX5900/CX6000/DX6000/DX6050 Revision A
TROUBLESHOOTING Error Indications and Fault Occurrence Causes 93
Note : “–”: No change
Note *1: Stylus CX4900/CX4905/CX5000/DX5000/DX5050 only
*2: Stylus CX5900/CX6000/DX6000/DX6050 only
Table 3-4. Error Indications and Fault Occurrence Causes
Printer Status Replace Ink Cartridge or No Ink Cartridge CSIC Error Incorrect I/C Paper Jam
LEDs*
1
Power — — — —
Error Off Off Off Blink
Ink On On On Off
Memory
Card
1 — — — —
2 — — — —
3 — — — —
7-seg. — — — —
Paper
Type
1 — — — —
2 — — — —
Paper
Size
1 — — — —
2 — — — —
Fit to Page — — — —
LCD*
2
E-01/E-02 E-01/E-02 E-01/E-02 E-04
Status monitor 3
message
Fault
Occurrence
Cause
This error is detected when;
• The ink consumption amount reaches 100%.
• The ink cartridge is defective.
Note :
The slight amount of the ink is remaining in the
I/C even if the Replace Ink Cartridge error is
detected. This is to prevent the Print Head nozzle
from the printing operation without firing the
ink.
This error is detected when data from CSIC
cannot be read normally or when data
cannot be written to CSIC.
This error is detected when;
• An unsupported ink cartridge has been
installed.
• An ink cartridge with a different
destination has been installed.
This error is detected when the PE Sensor
cannot properly detect the paper bottom
edge during feeding of paper.
Reference Page
“3-10 Check point for no ink cartridge/
CSIC error/incorrect ink cartridge
according to each phenomenon” (p.103).
“3-10 Check point for no ink cartridge/
CSIC error/incorrect ink cartridge
according to each phenomenon” (p.103).
“3-10 Check point for no ink cartridge/
CSIC error/incorrect ink cartridge
according to each phenomenon” (p.103).
“3-11 Check point for paper jam error
according to each phenomenon” (p.104)
.