28 Setup
3. Loosen the detector adjustment screw using a coin or similar tool.
4. The adjustment position of the roll paper Near-End detector changes depending on the way
of installation. In either case (vertical or horizontal), adjust the detector so that its tab comes
out from the hole near the bottom of the printer. (Refer to "Adjusting Roll Paper Near-End
Detection Position" on page 27, "Adjustment Positions of N.E. Detector" on page 29.
Note:
When changing the position of the N.E. detector in accordance with the change of installation, move the
roll paper N.E. detector as the above arrow shows while holding down the detector.
Detector
adjustment
screw
Move the N.E. detector
holder in the direction
of the arrow to make
the detector come out
from the window for
either vertical or
horizontal installation.
To Next Page
Loading...
