Setup 33
TM-L90/TM-L90 Peeler Model Technical Reference Guide
Note:
Move the N.E. detector in the direction shown by arrow.
Near end sensor holder
Note:
Adjust the sensor while checking the position of the parts circled in the following figure.
Near end sensor adjustment position
Adjustment scale Outside diameter of specified thermal paper
#1 Approximately 36 mm {1.42"}
#2 Approximately 41 mm {1.61"}
N.E. detector holder
Adjustment direction
when the sensor holder position is #1
when placed vertically
when the sensor holder position is #2
when placed vertically
To Next Page
Loading...
