Setup 49
TM-L90/TM-L90 Peeler Model Technical Reference Guide
❏ Depending on the paper type, it is recommended to set the print density as shown in the table below
for the best print quality.
Serial communication conditions
Note:
For models other than 4** models, these settings are valid only when the DIP switch 1-2 is Off.
USB communication conditions (only for 4** models)
This setting is valid for the built-in USB.
Paper type Density level
Receipt P35024 90%
KF50 95%
F5041(55) 100%
Label 150PSMW 120%
DTM9502, KL80GT 130%
Item
Option
(underlined: initial setting)
Msw Setting
utility
Msw Setting
Mode
Baud rate 2400, 4800, 9600, 19200
, 38400, 57600,
115200 bps
✓✓
Parity None
, Odd, Even ✓✓
Flow control DTR/DSR
, XON/XOFF ✓✓
Data length 7-bits, 8-bit
s ✓✓
Item
Option
(underlined: initial setting)
Msw Setting
utility
Msw Setting
Mode
Class Vendor-defined class
, Printer class ✓✓
To Next Page
Loading...
