Epson TM L90 - Page 51

Setup 51
TM-L90/TM-L90 Peeler Model Technical Reference Guide
Msw7 (only for 39* models)
[Msw7-8] is enabled only in the continuous issuing mode.
When [Msw7-8] is Off, the printer feeds paper to the next print starting position, if the FEED button is
pressed.
When [Msw7-8] is On, if you press the FEED button once, the printer feeds one piece of the label to the
manual cutting position. Then if you press the FEED button again, the printer feeds the next label to the
print starting position. By pressing the FEED button repeatedly, the operation described above is repeated.
Msw8
If [Msw8-1] is OFF, the paper is determined automatically if the printer recovers from the paper
layout error.
Furthermore, the results of automatic paper determination are overwritten if the settings for
paper layout are already saved in the NV memory.
Msw Function Off On
Initial
setting
Msw Setting
utility
Msw Setting
Mode
7-1
to
7-7
(Reserved) - - Off
7-8 Function when FEED button is
pressed
Feed to the
next print
starting
position
Feed to the
manual
cutting
position
Off ✓✓
Msw Function Off On
Initial
setting
Msw Setting
utility
Msw Setting
Mode
8-1 User operation for recovery
from paper layout error
Recovers by
pressing FEED
button
Does not
recover by
pressing FEED
button
Off ✓✓
8-2 User operation for recovery
from paper layout error
Send the error
recovery
command or
open/close
the cover
Send the error
recovery
command
Off ✓✓
8-3 Paper out LED state in a paper
near-end
LED On LED Off Off ✓✓
8-4 Maximum length of automatic
paper measurement
160 mm 300 mm Off ✓✓
8-5 Space insertion at left and
right side of barcode print
Disabled Enabled Off ✓
8-6 Paper feed to the print starting
position when power is turned
on
Enabled Disabled Off ✓✓
8-7 (Reserved) - - Off
8-8 Printer cover open during
operation
Automatic
recoverable
error
Recoverable
error
Off ✓