62 Setup
5. For peeling issuing, set the end of the roll paper in the peeler, and for continuous
issuing, set it in the ejection path, and close the roll paper cover. The printer feeds
several labels and remembers the label paper size. This completes the task.
6. For peeling issuing, after setting the paper, the PAPER OUT LED flashes. To print, insert
the label into the peeler path, and press the FEED button.
If an error occurs without completing the setting, turn the power off, and repeat the
operation from step 3.
The automatic paper layout value is set according to the following expression.
L3:(L2+1.5) mm:
L
4:(L22/5) mm:
L
5:(L1-L2-3) mm
L6: 4.7 mm (fixed value)
L
7: When the liner width is 78 mm or more:70 mm
When the liner width is less than 78 mm:(Liner width -8) mm
To Next Page
Loading...
