ergoline ERS 2 - Selecting the Protocol Type; Protocol Type HR-Controlled

32 |
patiEnt data > protoCoLs
trEadMiLL
The illustration shows relevant informa-
tion such as:
- training heart rate
- warmup phase
- training duration
- blood-pressure measurement
- speed and slope
- recovery phase
Under Protocols, you will find the Tread-
mill Default* protocol. This is a precon-
figured protocol. More than one protocol
can be assigned to a patient.
The description below explains the con-
figuration of custom training protocols.
All parameters can be defined easily and
accurately.
· Warmup
· Increase
· Training
· Decrease
· Recover
Creating a Protocol
With [ Create ] you configure a new pro-
tocol. Enter a protocol name (for exam-
ple, Protocol 1) and select a protocol
type. Specify all required criteria.
Save the protocol with [ Apply ] or delete
all entries with [ Discard ].
By saving the protocol, you add it to the
drop-down list of protocols.
| 33
patiEnt data > protoCoLs
trEadMiLL
Selecting the Protocol Type
These are the protocol type choices:
· Constant Workload
· HR-controlled (Speed)
· HR-controlled (Slope)
· HR-controlled
· Custom
· Constant Workload
permanent load without interruptions
at a constant intensity
· HR-controlled (Speed)
the predefined training heart rate is
achieved via the speed
· HR-controlled (Slope)
the predefined training heart rate is
achieved via the slope
· HR-controlled
the predefined training heart rate is
achieved both via the speed and the
slope
· Custom
use individual step types to configure
personalized training sessions
Protocol Type ‘HR-controlled’
With this protocol, the speed regulation
for the training phase always starts with
a slope setting of 0. The slope will be in-
creased only if the heart rate cannot be
achieved via the speed during the train-
ing phase.