ergoline ERS 2 - Editing the Default Protocol; Activating the Default Protocol; Deleting the Default Protocol; Management > Protocols

44 |
ManagEMEnt > protoCoLs
b
iCyCLE
Protocol Type ‘Custom’
With [ Edit ] you can change the duration
and load of the steps. Mark individual or
consecutive steps (highlighted blue) and
enter the values for Duration (abs. [s]/
rel. [%]) or Load (abs. [W]/rel. [%]) us-
ing the keyboard or the arrow buttons
. Select [ Apply ] to adopt the new
values. To close the window, click [ Apply ]
once more.
Editing the Default Protocol
To edit a Default Protocol click [ Edit ].
Edit the settings and close the window
with
[ Apply ]. The changes will be effec-
tive from now on.
Activating the Default Protocol
You activate a Default Protocol by click-
ing [ Extended ] and Activate. Answer the
question in the next window with [ Yes ].
The Default Protocol is now active which
can be recognized by the asterisk *.
Deleting the Default Protocol
To delete a Default Protocol, click
[ Extended ] and select Delete.
If you confirm the command with
[ Yes ],
the protocol will be deleted. It is no lon-
ger available for selection.
Please note that it is not possible to de-
lete an active protocol!