ergoline ERS 2 - Selecting the Training Protocol

54 |
training
Monitoring
Marking the ECG
To highlight artifacts in the ECG, right-
click in area 2 and select Mark ECG.
Turning the ECG Pump On
To turn on the ECG pump from the short-
cut menu in area 2, select Turn on ECG
Pump.
Turning the ECG Pump Off
To turn off the ECG pump from the
shortcut menu in area 2, select Turn off
ECG Pump.
Training View
This screen provides an overview of the
training session, the protocol, the du-
ration, and the METs value (additional
parameters if provided by the training
device). Depending on the configura-
tion and device type, various parameter
values can be selected from the short-
cut menu for graphic representation.
With a right mouse click into area 3 and
choosing Training Display or with a dou-
ble-click on the curve display you switch
to the Patient Training.
This view presents all parameters se-
lected via Patient Data - Protocols or in
Management - Protocols. The training
stations are displayed on the right side.
| 55
training
Monitoring
Selecting the Training Protocol
With a right click in area 3 and by choos-
ing Select Training Protocol you access
the protocols (this is not possible while a
training is in progress). The new window
shows all Protocols created in Patient Data
or Management.
Define a protocol for the patient either with
a double-click or by selecting the protocol
and clicking [ OK ].