ero electronic MKC - Page 134

B. 2
HIGH THRESHOLD USED WHEN ALARM 4
IS A BAND ALARM ................................................. 76
LOW THRESHOLD USED WHEN ALARM 4
IS A BAND ALARM ................................................. 76
CONTROL ACTION ................................................ 79
Run time group 4 - CONTROL PARAMETER ......... 78
EXTERNAL CONTROL OF AUTO/MAN
MODE ...................................................................... 84
EXTERNAL CONTROL OF LOCAL/REMOTE
SETPOINT SELECTION ......................................... 84
EXTERNAL CONTROL OF REVERSE/DIRECT
OUTPUT ACTION SELECTION .............................. 84
FEEDBACK POTENTIOMETER
ADJUSTMENT ENABLING ..................................... 93
Run time group 8 - FEEDBACK
POTENTIOMETER CALIBRATION ........................ 93
FEEDBACK HIGH LIMIT CALIBRATION ................ 94
FEEDBACK LOW LIMIT CALIBRATION ................. 93
OFD ALARM ACTION ............................................. 91
OFD ALARM CONFIGURATION ............................ 91
RATE OF CHANGE FOR POSITIVE
SETPOINT VARIATION .......................................... 83
RATE OF CHANGE FOR NEGATIVE
SETPOINT VARIATION .......................................... 83
Run time Menu hidden SMART LIMIT VALUE ........ 95
ALARM 1 HYSTERESIS ......................................... 77
ALARM 2 HYSTERESIS ......................................... 77
ALARM 3 HYSTERESIS ......................................... 77
ALARM 4 HYSTERESIS ......................................... 77
HYSTERESIS .......................................................... 78
INTEGRAL PRE-LOAD ........................................... 79
MAIN CONTROL OUTPUT HIGH LIMIT ................. 81
MAIN CONTROL OUTPUT LOW LIMIT .................. 81
MAIN CONTROL OUTPUT MAX RATE
OF RISE .................................................................. 81
MANUAL RESET (ACKNOWLEDGE) OF
THE ALARMS ......................................................... 73
MAIN OUTPUT CYCLE TIME ................................. 81
DEAD BAND/OVERLAP BETWEEN MAIN
AND SECONDARY OUTPUT ................................. 79
PROPORTIONAL BAND ......................................... 78
MAX VALUE OF PROPORTIONAL BAND
CALCULATED BY THE SMART ALGORITHM ....... 96
MIN VALUE OF PROPORTIONAL BAND
CALCULATED BY THE SMART ALGORITHM ....... 96
POSITIONING OF SERVO AT HIGH LIMIT ........... 94
POSITIONING OF SERVO AT LOW LIMIT ............ 93
RELATIVE SECONDARY OUTPUT GAIN .............. 79
Xkc-B-C0.p65 5/29/02, 12:01 PM2