MAINTENANCE MANUAL
Page 71-26
Effectivity: All
Edition 2 | Rev. 0
Legend to Fig. 71–7
1 Airbox 21 Strut attachment
2 Left sump of carburettor 22 Cobra clamp
3 Right sump of carburettor 23 Hose clamp
4 Strut 24 Wire
5 Silent block 25 Screw M4
6 Left connecting hose 26 Screw M5
7 Right connecting hose 27 Screw M4
8 Inlet hose – cold air 28 Nut M4
9 Inlet hose – hot air 29 Nut M4
10 Attachment of bowden cable 30 Nut M5
11 Setting end piece of bowden
cable
31 Washer 5,3
12 Bowden string 32 Washer 5,3
13 Bowden hose 33 Washer 4,3
14 Return spring 34 Washer 6,4
15 Connecting pull-rod 35 Nut M6
16 Drain hose of left sump of
carburettor
36 Nut M5
17 Left drain hose of airbox 37 Nut M5
18 Right drain hose of airbox 38 Lever of right regulation flap of airbox
19 Venting hose of carburettor 39 Bracket of bowden cable
20 Venting hose of carburettor
Fig. 71-7 Airbox – removal / installation (page 2 of 2)
(4) Removal – carburettor preheating control
(a) Switch the electrical network off and disconnect the battery.
(b) Loose the screw (7, Fig. 71–8) and remove the handle (1).
(c) Unscrew the nut (5) and remove the washer (6).
(d) Remove the carburettor preheating control on the airbox (see par. 2 A.(2)).
(e) Slide out the string with tube (3) from the terminal (2).
(f) Loose the screw (8) and remove the bowden hose (4).
(g) Remove the terminal (2).
(5) Installation – carburettor preheating control
(a) Insert the bowden hose (4, Fig. 71–8) into the terminal (2) and secure it by means
of the screw (8).
(b) Insert the terminal (2) with bowden hose into the appropriate hole in the central
console (9), insert the washer (6), screw and tighten the nut (5).
(c) Insert the string with tube (3) into the body (2).
(d) Instal the carburettor preheating control on the airbox (see par. 2 A.(3)).
To Next Page
Loading...
