evertz VIP-X - On Board Server Setup

VIP-X System Manual
Revision 1.0 VIP-X - 47
9.2.2. On Board Server Setup
2) On Board Server Configuration – This menu option is used to set up the internal server properties
of the VIP module.
Server: The Server should be enabled for normal VIP operation. In a system where the VIPX
external PC based server is used the server should be disabled.
GPId: The GPId should be enabled when using GPIs to load layouts on the VIP module.
VGPId: The VGPId should be enabled when using virtual GPIs to load layouts on the VIP
module.
DCPd: The DCPd should be enabled when using the 3000DCP desktop control panel with the
VIP.
SYMPHd: The SYMPHd should be enabled when using the Symphony Third Party protocol. The
third party protocol allows for external control devices to change layouts on the VIP. The
communication of this control is done using TCP/IP default port = 9750. Please see
Evertz’ Symphony Protocol version 1 for more details regarding the protocol itself.
------------------------------------------------
Onboard Server: Enabled
Onboard GPId: Disabled
Onboard VGPId: Disabled
Onboard DCPd: Disabled
Onboard SymphD: Disabled
------------------------------------------------
(1) Display connection status
(2) Enable server
(3) Enable gpid
(4) Enable vgpid
(5) Enable dcpd
(6) Enable symphd
(S) Save and Exit
(X) Exit
>