evertz VIP-X - Auxiliary Serial Port Setup; SNTP Setup - Network Time Protocol

VIP-X System Manual
Revision 1.0 VIP-X - 49
9.2.5. Auxiliary Serial Port Setup
5) Auxiliary Serial Port Setup: If utilizing the serial port for dynamic UMD information, use this
menu option to set the serial port parameters.
Auxiliary Serial Port Setup: (Use the following settings to configure the auxiliary serial port)
Baud Rate
9600
Data Bits
8
Parity
None
Stop Bits
2
Standard
RS-232
------------------------------------------------
(1) Set baud rate
(2) Set number of data bits
(3) Set parity
(4) Set number of stop bits
(5) Set standard
(S) Save and exit
(X) Exit without saving
9.2.6. SNTP Setup – Network Time Protocol
6) SNTP Source – This menu option is used to set the NTP server source IP address. Set the IP
address for the NTP server on the network. The VIP must be on the same network in order to contact
the server. This menu will also display the last updated network time.
------------------------------------------------
Active sntp source: 0.0.0.0
New sntp source: 0.0.0.0
Last time sntp updated at
sntp time: 0:0:0
------------------------------------------------
(1) Set SNTP Source Address
(S) Save and Exit
(X) Exit
>