evertz VIP-X - Figure 11-7: Auxiliary Serial Port Setup; Figure 11-8: Setting up XY Integrator Protocol Operation

VIP-X System Manual
VIP-X - 68 Revision 1.0
Ensure the settings match those listed below:
------------------------------------------------
| Auxiliary Serial Port Setup |
| (7767VIPX8x2 1.0.0) |
------------------------------------------------
------------------------------------------------
Baud Rate: 9600
Data Bits: 8
Parity: None
Stop Bits: 1
------------------------------------------------
(1) Set baud rate
(2) Set number of data bits
(3) Set parity
(4) Set number of stop bits
(S) Save and Exit
(X) Exit
>
Figure 11-7: Auxiliary Serial Port Setup
6. Select (4) Under Monitor Display Setup from the main menu to set up the display card for XY
Integrator protocol operation.
------------------------------------------------
| Under Monitor Display Setup |
| (7767VIPX8x2 1.0.0) |
------------------------------------------------
------------------------------------------------
Protocol: XY Integrator
Input Type: serial
------------------------------------------------
(1) Set protocol
(S) Save and Exit
(X) Exit
>
Figure 11-8: Setting up XY Integrator Protocol Operation
7. Wire the serial connection from the router/switcher to the auxiliary serial port of the VIPX.
8. Power-cycle the VIPX frame.
9. Using Maestro, add a UMD to a video object by dragging and dropping it onto the video object.
10. Navigate to Mode Settings > Mode > Function, and select Protocol ID from the drop-down box.
11. Set the Active Protocol ID to match the video mapping defined by the router/switcher.