evertz VIP-X - 3000 DCP Desktop Control Panel Configuration; PC-Based DCP Setup

VIP-X System Manual
Revision 1.0 VIP-X - 75
13. CONFIGURING THE 3000 DCP DESKTOP CONTROL PANEL
Please note that this section assume that the System Configuration Tool (SCT) has already been
installed and configured.
13.1. FOR PC – DCP SETUP
1. Press the Select and Setup buttons on the DCP at the same time to enter the setup menu.
2. Ensure that the DCP has the correct IP address as entered in the Hardware Setup Table.
3. Verify all network settings. Use the arrow buttons and rotary knob to enter network information.
Also ensure that the DCP is connected to the same network as the VIP-X, and can be pinged from
the PC running the Maestro application.
It may take a few seconds in order for the DCP to connect.
When it does, the dot-matrix display will go from displaying “No Clients Connected” to “Evertz 3000DCP
DCPd@ xxx.xxx.xxx.xxx”.
DCP presets are saved using the format “dnn-pnn”, where nn is the display number and preset button
number.
Use the Maestro software to save presets as a script (File > Save as script) using the described
format. Maestro will automatically place the preset for the DCP in the correct location.
Example:
d01-p01, assigns the preset to display 1 preset button 1
d01-p12, assigns the preset to display 1 preset button “shift” 2 (12)
d04-p08, assigns the preset to display 4 preset button 8