evertz VIP-X - Page 7

VIP-X System Manual
Revision 1.0 VIP-X - iii
9. MODULE CONFIGURATION ........................................................................................................43
9.1. CONFIGURING THE MODULE VIA THE CARD EDGE MENU...........................................43
9.1.1. Configuring the Display .............................................................................................44
9.2. CONFIGURING THE MODULE USING THE MODULE SERIAL PORT..............................45
9.2.1. Network Configuration...............................................................................................46
9.2.2. On Board Server Setup .............................................................................................47
9.2.3. SNMP Configuration..................................................................................................48
9.2.4. UMD Setup................................................................................................................48
9.2.5. Auxiliary Serial Port Setup.........................................................................................49
9.2.6. SNTP Setup – Network Time Protocol ......................................................................49
9.2.7. Network Audio Setup – Future Enhancement Feature..............................................50
9.2.8. Nielsen Configuration ................................................................................................50
9.3. WEB SERVER INTERFACE.................................................................................................51
9.3.1. Card Setup: Display Setup .......................................................................................51
9.3.2. Card Setup: Network Setup......................................................................................52
9.3.3. Card Setup: SNMP Setup.........................................................................................53
9.3.4. Card Setup: UMD Setup...........................................................................................54
9.3.5. Card Setup: Server Setup ........................................................................................55
9.4. MVP/VIP MAESTRO SOFTWARE .......................................................................................56
10. UPGRADING FIRMWARE ............................................................................................................57
10.1. UPGRADING THE FIRMWARE USING FTP .......................................................................57
10.1.1. Step 1 – Determine the IP Addresses .......................................................................57
10.1.2. Step 2 – Establishing a Valid Network Connection ...................................................57
10.1.3. Step 3 – Upgrading the Application Code .................................................................58
10.1.4. Step 4 – Completing the Upgrade .............................................................................60
10.2. UPGRADING THE FIRMWARE USING RS-232 SERIAL CABLE ......................................61
10.2.1. Step 1 – Setup...........................................................................................................61
10.2.2. Step 2 – Invoke Upload Mode from the Terminal Program .......................................61
10.2.3. Step 3 – Uploading the New Firmware......................................................................62
10.2.4. Step 4 – Completing the Upgrade .............................................................................62
11. SETTING UP PROTOCOLS..........................................................................................................63
11.1. SETTING UP VIPX TO WORK WITH IMAGE VIDEO PROTOCOL.....................................63
11.2. SETTING UP VIPX TO WORK WITH TSL PROTOCOL......................................................64
11.3. SETTING UP VIPX TO WORK WITH X-Y PROTOCOL.......................................................66
11.3.1. Creating the Text Files ..............................................................................................66
11.3.2. Setting Up the Display Card(s) ..................................................................................67
11.4. SETTING UP VIPX TO WORK WITH ASCII PROTOCOL ...................................................69
11.4.1. Creating the Text File ................................................................................................69
11.4.2. Setting Up the Display Card(s) ..................................................................................70