EVOCA La Radiosa - Page 74

66 05-2019 0073 00
wi-fi
Enable the Wi-Fi connection to congure
the appliance to the Wi-Fi network.
1. Enter the name of the Wi-Fi network
(SSID) to which the appliance will be
connected.
2. Choose the encryption used by the Wi-Fi
network; the appliance supports the main
Wi-Fi protection systems.
 “Open” encryption does not guarantee
any type of protection.
3. Enter the Wi-Fi password for access. The
display password parameter can be used
to view the entered password.
4. The network parameters (such as the IP
address, etc.) can either be automatical-
ly (DHCP to ON) or manually (DHCP to
OFF) set.
 -
rameters, there must be a DHCP server

If the parameters are manually set, the fol-
lowing must be entered:
-The IP address that you want to assign to
the appliance.
-The subnet mask to which the IP address
belongs.
-The gateway (router) IP address.
-The IP address of the resolving name
server (DNS server).
 If an error is made when manually
entering the parameters or an IP ad-
dress that is already in use on the Wi-Fi


You can check if the connection is working
from this function.
The MAC address is a unique address
assigned by the manufacturer that identies
the appliance’s network card.
The MAC address cannot be changed.
bluEtootH
Enables and congures the Bluetooth
connection and allows short-range data
exchange (a maximum of ten metres) be-
tween the appliance and other devices.
To connect to a Bluetooth device you need
to:
-Enter a name so that the appliance can be
identified.
-Make the appliance discoverable when
searching for Bluetooth devices (Searcha-
ble to ON).
In detection mode, a wireless signal is
transmitted which allows the appliance to
be detected by other devices.
-Enter the PIN authentication code in or-
der to be able to associate the Bluetooth
device.
When a device can be detected, the pairing
mode is also usually enabled.
All of the appliance’s linked devices are
shown.
mobilE NEtwork Data coNNEctioN
sEttiNgs
Enables and congures the mobile network
data connection parameters.
Enable the data connection in order to view
and congure the parameters.
The parameter values (e.g., PIN, APN ad-
dress, access data such as the username
and password, etc.) vary according to the
chosen telephone service provider: request
these from your service provider.
The signal strength of the mobile network
can be seen from this function.