Test Setup - Test Configurator, Timer, and System
MaxTester 115
Interface
WIS Button
Note: WIS is only available for 10GE WAN interface.
J0 Trace allows setting the J0 Trace value in 16 bytes format (default is
EXFO 10GigE).
J1 Trace allows setting the J1 Trace value in 16 bytes format allowing
up to 15 bytes (a CRC-7 byte will be added in front for a total of
16 bytes). Default is EXFO 10GigE.
Note: J0 and J1 values should be 7-bit T.50 suitable characters. The Padding drop
list from the message keyboard allows selecting Null or Space to fill up the
J0 Trace and J1 Trace up to15-byte value. The Control Characters button
in the J0 Trace and J1 Trace message keyboard, allows selecting the
required character. For more details on Control Characters, see page 30.
Path Signal Label (C2) byte is allocated to indicate the content of the
STS SPE, including the status of the mapped payload.
C2 (Hex.) Description
00 Unequipped
01 Equipped - Non-Specific
1A
a
a. Default value.
10 Gbit/s Ethernet (IEEE 802.3)
FE Test Signal, ITU-T 0.181
To Next Page
Loading...
