Test Setup - Test Configurator, Timer, and System
MaxTester 125
MAC/IP/UDP
Flood Range is the range of the least significant bits used for the
Source Flooding and/or Destination Flooding: 2(1bit), 4(2bits),
8(3bits), 16 (4 bits)... up to 16777216 (24 bits) (default).
VLAN
Note: VLAN is only available when the VLAN Tag is enabled; refer to Modify
Frame Structure on page 122.
For each VLAN tag enabled (C-VLAN/S-VLAN/E-VLAN) the following
parameters are configurable.
VLAN ID choices are 0 through 4095; refer to VLAN ID and Priority on
page 467 for more information.
Priority, VLAN user priority, choices are 0 (default) to 7. Refer to VLAN
ID and Priority on page 467 for more information.
Type, VLAN Ethernet Type, choices are 8100 (default for C-VLAN),
88A8 (default for S-VLAN), 9100 (default for E-VLAN), 9200, and 9300.
Drop Eligible:, when set to Yes (DEI = 1), the transmitted frames will
be dropped first on receipt when congestion occurs under test. Drop
Eligible is not available when VLAN type is 8100. This parameter is set
to No by default.
To Next Page
Loading...
