Test Setup - Test Configurator, Timer, and System
124 MAX-800 Series
MAC/IP/UDP
EtherType is set to the following values by default and is configurable
from 0x0000 to 0xFFFF when the Network Layer is set to None:
0x0000 when Network Layer is set to None
0x0800 for IPv4
0x86DD for IPv6
0x8847 for MPLS
0x88B7 when Network Layer is set to None with EtherBERT test
Note: Depending on the Layer Mode (available with EtherSAM), some EtherType
require to set the configuration parameters through the Modify Frame
Structure pop-up instead of configuring its value from this field; in this case
a pop-up message is displayed indicating the reason. The following
EtherType are not supported for Mixed layer mode: 0x0001 to 0x05FF and
0x8870.
OUI, available when the frame format 802.3 SNAP is selected, allows
the selection of the Organizationally Unique Identifier (OUI):
RFC1042 (0x000000) - (default)
User Defined, available when Network Layer is set to None, allows
entering the OUI value: 0x000000 (default) to 0xFFFFFF.
Note: Source/Destination Flooding and Flood Range are only available with
Traffic Gen & Mon when the Network Layer is set to None (see page 122).
Source Flooding and Destination Flooding check boxes when
selected (cleared by default) allows generation of frames using
source/destination MAC addresses flooding as follows: The first frame
is transmitted starting with the least significant bits of the
source/destination MAC address covered by the range set to 0; each
subsequent frame is transmitted by incrementing the least significant
bits by 1; when the upper limit of the range is reached, the
source/destination MAC address restarts over with the least significant
bits covered by the range set to 0.
To Next Page
Loading...
