Test Setup - Test Configurator, Timer, and System
MaxTester 123
MAC/IP/UDP
MPLS: The MPLS Label check box, when selected (cleared by
default), enables 1 or 2 MPLS labels allowing management and test
frames to be transmitted and received. Only available with EtherSAM
and Traffic Gen & Mon test applications. Not available with EtherSAM
when Layer Mode is set to L2 Only.
VLAN: The VLAN Tag check box when selected (cleared by default),
enables up to 3 stacked VLAN.
See VLAN on page 125 for additional VLAN settings.
Preamble/SFD
Indicates that the frame structure contains the Preamble and SFD.
MAC
Source MAC Address indicates the default and unique Media Access
Control (MAC) address given to the Ethernet port.
Destination MAC Address: Enter the destination MAC address for the
stream. The default setting is the source MAC address. The destination
MAC Address field is not accessible when the Resolve MAC Address
check box is selected.
Resolve MAC Address check box, when selected (default), sends a
request to the network to retrieve the MAC address corresponding to
the selected destination IP address. This setting is coupled with the
Resolve MAC Address check box from IP on page 127. This check box
is not available when the Network Layer is set to None (refer to Modify
Frame Structure on page 122).
To Next Page
Loading...
