EXFO MAX-890 - Page 151

Test Setup - Test Configurator, Timer, and System
MaxTester 143
RFC 2544 - Subtests
 Max. Rate is the maximum rate the test should begin with, in terms of
a percentage of the line rate (%), Mbit/s, or Gbit/s. For Dual Test Set
Max. Rate is configurable for both local (L) and remote (R) directions.
For Dual Port topology, Max. Rate is configurable for both port
directions.
 Trial Duration is the time for each trial in minutes:seconds: 1 second
(default) to 30 minutes.
 Trials is the number of times the throughput test will be generated:
1 (default) to 50 trials.
Interface
Speed
Max. Rate
% Mbit/s Gbit/s
10 Mbit/s 0.0050 to 100.0000
a
a. Default value.
0.00001 to 10.000
a
Not Applicable
100 Mbit/s 0.0050 to 100.0000
a
0.0001 to 100.000
a
Not Applicable
1000 Mbit/s 0.0050 to 100.0000
a
0.001 to 1000.00
a
0.000001 to 1.000
a
10G LAN 0.0050 to 100.0000
a
0.01 to 10000.000
a
0.00001 to 10.000
a
10G WAN
b
b. The maximum value for 10G WAN may be lower depending on the frame size. The
maximum value will be adjusted for each frame size.
0.0005 to 92.8571
a
0.01 to 9285.71
a
0.00001 to 9.28571
a
100G 0.0050 to 100.0000
a
5.00 to 100000.0
a
0.00500 to 100.0000
a