IEEE 802.3 Media Access Standards
IEEE 802.3ab 1000BASE-T
IEEE 802.3at PoE
IEEE 802.3ae 10GBASE-X
IEEE 802.3az Energy Efcient Ethernet
Power Cord Requirements for AC-Powered Switches and AC Power
Supplies
An AC power cord is not included with the AC power supply.
Power cords used with AC-powered switches or AC power supplies must meet the
following requirements:
• The power cord must be agency-certied for the country of use.
• The power cord must have an appropriate AC connector for connection to the switch
or power supply.
• The power cord must have an appropriately rated and approved wall plug applicable
to the country of installation.
• For cords up to 6 feet (2 m) long, the wire size must be 18 AWG (.75 mm
2
) minimum;
over 6 feet, the minimum wire size is 16 AWG (1.0 mm
2
).
For details about obtaining AC power cords for use in your country, refer to http://
www.extremenetworks.com/product/powercords/.
Console Connector Pinouts
Table 22 describes the pinouts for a DB-9 console plug connector.
Table 22: Pinouts for the DB-9 Console Connector
Function Pin Number Direction
DCD (data carrier detect) 1 In
RXD (receive data) 2 In
TXD (transmit data) 3 Out
DTR (data terminal ready) 4 Out
GND (ground) 5 -
DSR (data set ready) 6 In
RTS (request to send) 7 Out
CTS (clear to send) 8 In
Figure 65 shows the pinouts for a 9-pin to 25-pin (RS-232) null-modem cable.
Power Cord Requirements for AC-Powered Switches
and AC Power Supplies Technical Specications
108 ExtremeSwitching 5320 Series Hardware Installation Guide
To Next Page
Loading...
Need help?
General
