The Power LED is located on the rear panel of the RPS. The following table presents the
LED status and recommended actions if the LED is off.
Color Status Recommended Action
Green AC input to RPS is
within specications.
None.
Off AC input power
to RPS is out of
specication.
1. Check AC power cord connection to the
RPS.
2. Check AC power at the power outlet.
3. Swap power cord for a known good one.
If the problem persists, contact Extreme
Networks for support.
External Redundant Power Supply LEDs Monitor the Switch
94 ExtremeSwitching 5320 Series Hardware Installation Guide
To Next Page
Loading...
