Extron electronics DTP CrossPoint 4K Series - Page 120

DTP CrossPoint 4K Series Matrix Switchers • Matrix Software 112
Switcher-to-output mixer block (see figure 53 on page 97,
G
)
NOTE: Figure 57 shows the 10x8 matrix size. Other models have either 6, 4, or 2 outputs.
The switcher-to-output mixer block (see figure 57) sends audio from the AV matrix block to
the output. It is an array of points where the output of the AV matrix can be mixed into the
output of the DSP. The block provides a way to mute and unmute the output of the AV block
onto the path to the physical audio connectors. The mix-points ( and ) are unmuted by
default. Unmuting effectively mixes the inputs into the audio outputs at the level set in the
left and right mix controls.
Switcher-to-output
Mixer
}
}
}
Mic Inputs
Virtual Returns
Expansion Inputs
Audio Outputs
1 through 8, Left and Right
Virtual
Send Bus
1111111111
33
33333333
44
44444444
22
22222222
Figure 57. Switcher-to-output Mixer Block and Mix-point Dialog Box,
DTP CrossPoint 108 4K Shown
To mute or unmute an input, double-click one of the mix-points (
1
) to open a mix-point
dialog box. Click the Mute button (
2
) in the dialog box to unmute or mute the applicable
input. The appearance of the mix-point indicates the input connection status as follows:
Unmuted
Muted
The mix-point dialog box features a fader control that provides a mix (level) adjustment with
a gain range of -100 to +12 dB in 0.1 dB increments. Click and drag the fader (
3
) or click
in the dB field (
4
) and enter a value. The default setting is unity gain (0 dB).
TIP: If an audio signal is output on the virtual bus and looped around back to the
virtual input, mute the audio output by the AV block in these mix-points to prevent the
unprocessed signal from being output along with the processed audio.