Extron electronics DTP CrossPoint 4K Series - Page 135

DTP CrossPoint 4K Series Matrix Switchers • Matrix Software 127
3. If you selected TCP/IP in step 2:
a. Observe the IP Address field in the IP Connection window. The field displays the
last IP address entered.
If the IP Address field is correct, proceed to step 3b.
If the address is not correct, either click in the IP Address field and enter the
IP address (see figure 70 on the previous page,
3
) or click on the scroll down
button ( ) to open a drop-down menu and select from among the recently used
addresses. Proceed to step 3b.
NOTE: If the local system administrators have not changed the value, the
factory-specified default, 192.168.254.254, is the correct value for this field.
b. If the switcher is password protected, click in the Password field and enter the
appropriate administrator password (
4
).
c. Click OK (
5
).
The Synchronize with Device dialog box opens (see figure 71 on the next
page). Proceed to step 6.
4. If you selected USB in step 2:
a. Click the USB Devices drop-down menu and select the switcher (
6
).
b. Click OK (
7
).
The Synchronize with Device dialog box (see figure 71) opens. Proceed to
step 6.
5. If necessary and as desired, click either the:
• Pull radio button (see figure 71,
1
) (to configure the DSP Configurator program
to match the switcher — proceed to step 7 on page 129)
• Push radio button (
2
) (to configure the switcher to match the DSP Configurator
program — proceed to step 6)
6. If you want to tailor the push to the switcher (push just the configuration, just the
presets, or the configuration and selected presets), click the Advanced button (
3
) and
proceed to step 6a.
To push all of the DSP Configurator ties, gain and processor blocks, and presets to the
switcher, proceed to step 7.
a. Select the Custom radio button (
4
).
b. Select one or both check boxes as desired; Push Configuration and Push
Presets (
5
).
NOTE: Configuration includes all ties, mic mixes, and gain and processor
blocks. This selection does not include presets.
c. If you selected Push Presets in step 6B, select either:
Selected (
6
)— A dialog box reopens that asks you to select the desired presets.
Proceed to step 6d.
All (equivalent to a standard push) (
7
)— Proceed to step 7.
d. Clicked Selected in step 6c — Click OK (
8
).
e. Select the desired presets to push by clicking the appropriate check boxes (
9
).
f. Click OK (
¢
). Proceed to step 8 on page 129).