Extron electronics DTP CrossPoint 4K Series - Page 145

DTP CrossPoint 4K Series Matrix Switchers • Matrix Software 137
Selecting a building block
Select a hand-held microphone configuration as follows:
1. Open the Building Blocks dialog box: Click the Mic Input1 number box. The
Building Blocks dialog box opens
(
1
).
Click the number.
A Building Block dialog box opens.
The modules in the box are dependent on the
device type clicked.
In this example, mic modules are shown
because a mic input was selected.
1111111111
2. Select the desired building block: Click Shure Beta 58
(
1
). The input channel
loads the pre-configured processor blocks, sets the gain, and renames the channel
Shure Beta 58.
NOTE: Common devices may be grouped in folders. If necessary, click a folder
(Handheld mic in the example below) to open it and make the building blocks
available for selection.
Click the desired input device.
The input device name and the processor chain change to shows the adjustments.
2222222222