Extron electronics DTP CrossPoint 4K Series - Page 22

DTP CrossPoint 4K Series Matrix Switchers • Installation 14
These switches tailor the TP output signals as follows:
• XTP position — Set this switch to the XTP position if the receiving device is an
Extron XTP CrossPoint matrix switcher. The TP output consists of HDMI with
embedded audio plus RS-232 and IR.
• HDBT position — Set this switch to the HDBT position for HDBaseT-enabled
receivers. The TP output consists of HDMI with embedded audio plus RS-232 and
IR.
• DTP position — Set this switch to the DTP position if the connected device is an
Extron DTP receiver. The TP output consists of HDMI with embedded audio, analog
audio, RS-232 and IR, and remote power.
F
TP output (see figure 4 and figure 5 on page 12) — Connect STP cables
SIG LINK
OUT
between these RJ-45 connectors and compatible Extron DTP receivers,
XTP matrix switchers, or HDBaseT-enabled devices (see TP connectors
on page 19 to wire the connector).
The following table identifies the TP outputs by matrix size.
Matrix Outputs Matrix Outputs
10x8 5B, 6B, 7, 8 8x6 3B, 4B, 5, 6
8x4 3B, 4B 8x2 1B, 2B
ATTENTION:
• Do not connect this port to a computer data or telecommunications network.
• Ne connectez pas ces port à des données informatiques ou à un réseau de
télécommunications.
NOTE: The video and embedded audio signal output on the TP output nB output is
duplicated on nA HDMI (for example, output 5A duplicates output 5B).