Extron electronics IN1806 Series - Page 84

IN1806 and IN1808 Series Scaling Presentation Switchers • SIS Configuration and Control 76
Command ASCII Command
(Host to Scaler)
Response
(Scaler to Host)
Additional Description
Audio Configuration (continued)
Configure Playback (continued)
Set delay
E
D
X8)
*
X8$
CPLY
}
CplyD
X8)
*
X8$]
Set the number of seconds the unit
waits before repeating playback of the
file in slot
X8)
.
View delay
E
D
X8)
CPLY
} X8$]
View number of seconds delay (
X8$
) set
for slot
X8)
.
Write name
E
N
X8)
*
X1$
CPLY
}
CplyN
X8)
*
X1$]
Assign name
X1$
to the file in slot
X8)
.
NOTE: Saving a file name as a single space repopulates the field with the default name (Audio•File•
X1$
).
View name
E
N
X8)
CPLY
} X1$]
View the name assigned to the file in
slot
X8)
.
Transport
Start and stop playback on
a slot
EX8)
*
X8@
PLAY
}
Play
X8)
*
X8@]
Set play/stop state
X8@
of slot
X8)
.
Play
X8)
*0
]
Unsolicited message sent when
playback of file
X8)
is complete.
NOTE: Audio file slots are in order of priority, highest (slot 1) to lowest (slot 16). During playback, if a higher priority slot
is requested, it takes precedence. The current slot stops playing and the selected higher priority slot begins. If a lower
priority slot is requested during playback of a higher priority one, an E22—Busy error message is returned.
View slot status
EX8)
PLAY
} X8@]
View playback status of the audio file in
slot
X8)
.
Global playback status
E
PLAY
} X8)]
View the slot (
X8)
) that is currently
playing.
Verbose modes 2 and 3:
Play0*0
]
Play
X8)
*1
]
No slot is currently playing.
Playback is active on slot
X8)
.
KEY:
X1$
= Playback text label Up to 32 characters, excluding , (comma) ,*, and
|
.
The default file name is Audio•File•
X1$
.
X8)
= Playback slot number
1 through 16
Highest priority for playback is slot 1, descending to lowest priority 16.
X8@
= Playback state
0 = Stop or stopped, 1 = Play or playing
X8$
= Playback delay
Number of seconds to wait before repeating playback on the current
audio file, if repeat has been enabled.
1 through 300 (1-300 seconds delay between repeats).
0 = No delay