SMP 111 • Introduction 6
TCP/IP
Network
MARK
RECORD
USB STORAGE
Outputs
HDMI/DVI
rear panel
local output
LAN
port
Deinter-
lacing,
scaling,
rasterizing
Frame rate
conversion
Record
encoding
Data
/
recording
Control
signals
+12 V
power
Stream
encoding
Recording
les
Internal
storage
External USB drive
(front or rear port, or
RCP 101)
and /or
AV
Controls
panel
preview
Str
archive
output
= Recorded le upload (if set up)
= Optional streamed output
Automatic
2
upload of
recording
to a
network
drive
2
For automatic uploading, set a default
destination (Extron Entwine EMP system,
Extron SCM system, Kaltura system,
Opencast system, or an FTP, SFTP, or CIFS
server location) to which to publish
recordings (Recorded Events >
Publish Settings).
(with or
without analog
line level
analog audio)
Figure 2. SMP111 Block Diagram
File Storage
Internal storage is available for storing recordings to be uploaded to a file server. The
SMP111 has a 32GB SD card internally, which is field upgradable to different storage
sizes (see Upgrading the SD Card on page111). You can view the total storage size in
the storage information table found on the File Management embedded web page (see
Storage Information in the Help file) or in the storage information table found on the
Device Status embedded web page.
Two USB ports (one on the front panel, one on the rear panel) provide a connection for
portable, user-provided USB drives for storing recordings.
The optional RCP 101 also has a USB port to connect a user-provided USB drive for storing
recordings.
figure 2