Extron electronics SMP 111 - Alarms and Traps

SMP111 • Web-Based User Interface 54
Alarms and Traps
In the Alarms and Traps page within Configuration, an administrator can configure
e-mail account and communication settings to allow the unit to send notification e-mails.
This is also the location for selecting whether to log, display a message about, or send an
e-mail about various conditions and errors experienced by the SMP111.
To open this page, click the Configuration tab (see figure 39,
1
) at the top of the
SMP111 embedded web pages and then click the Alarms and Traps tab (
2
) on the
second tier of tabs.
1
2
EDID
Figure 39. Configuration Tab, Alarms and Traps Subtab
The Alarms and Traps page (see figure 40) opens, showing the two drop-down panels:
1
2
EDID
Figure 40. Alarms and Traps Page
1
Alarm Notifier Destinations — Enter e-mail information for the person to be
notified of an alarm.
2
Alarm Message List — Choose the level of urgency for a given alarm on the
SMP111, or disable the alarm.
NOTE: If internal storage space is nearly full (at the point when the disk space alarm is
triggered) and the SMP111 is set up to automatically upload recordings to a server
(see Publish Settings Page on page 40), then the SMP uses an automatic disc
cleanup feature to make room for new recordings. As needed, the unit automatically
deletes previous recordings that have been uploaded to a server, starting with the
oldest recordings, until there is enough free space on the disk.
figure 39
figure 40