To Next Page

To Previous Page

SMP111 • Web-Based User Interface 36

Start an AdHoc Recording

A user logged on to the SMP, either at the user level or the administrator level, can initiate an

adhoc (unscheduled) recording.

NOTES:

• See Setting the Default Recording Media on page 56 within Conguration

> System Settings for more information about single and secondary storage

modes.

• If the unit is set for recording destination limiting, users do not have the option to

select a different storage location. The storage location or location are preselected

and cannot be changed from this dialog box.

• If the recording is restricted to a USB device with multiple partitions, then partition

selection within the USB drive is still available.

• Ad hoc recordings are set at unlimited time, but the user can Limit the

Duration under Recording Media Selection at a maximum of eight hours.

Start an adhoc recording from the AV Controls panel (see the SMP111HelpFile for

additional recording information).

If the unit is set for single storage mode (recordings are saved to only one storage drive),

choose a recording destination from the Recording Destination drop-down list found

in Conguration > System Settings > Recording Media Selection.

Figure 16. Ad-hoc Recording Destination Dialog, Single Recording Destination

If the unit is NOT set to limit the recording destination, recording destination options are as

follows:

• Auto — The recording is saved to the first available storage location that is not full. The

user sets the priority for storage location in the Destination Recording Priority

field.

• If a USB drive has more than one logical volume, only the volume with the largest

free space for that port in the Recording Destination: drop-down list is used

to store content. All other volumes on that drive are ignored.

• To record to another volume on the device you must manually select the target

location rather than using the auto option.

• Internal Drive — The recording will be saved on the internal 32 GB SD card.

• Front USB/Rear USB/RCP USB — The recording is stored to the indicated external

USB drive connected to the front panel, rear panel, or recording control panel USB

storage port on the SMP.

If the unit is set to limit the recording destination, you cannot change the storage location

(internal, front USB, rear USB). However, if the unit is set to store recordings to one of the

USB ports, and if the connected drive contains more than one volume, you can select a

volume from the Recording Destination drop-down list.

figure 16

Extron electronics SMP 111 User Manual

Other manuals for Extron electronics SMP 111