Extron electronics SMP 111 User Manual

SMP111 • Web-Based User Interface 56
9
Backup and Restore — Current SMP or IP configuration settings can be backed up,
or a previously saved configuration file can be restored to the unit from this panel (see
figure 42 on the previous page).
¢
Executive Mode — Allows you to enable or disable front panel lock-out to limit
access to the controls and functions of the SMP.
See the SMP111HelpFile for additional information.
Setting the Default Recording Media
To choose where a recording is saved during its creation:
1. In the System Settings page, click the Recording Media Selection panel bar
to expand it.
1
2
3
4
5
6
7
Figure 43. Recording Media Selection Panel
2. To save recordings to a single location:
a. Verify that the Enable Secondary Recording checkbox (see figure 43,
1
) is
disabled (unchecked).
b. In the Recording Destination drop-down list (
2
), select where recordings
should be stored during recording.
• Auto — The SMP stores the recording to available locations in the order of
priority set in the Destination Recording Priority field (
3
).
• Internal Drive — This forces the unit to store recordings only in its internal
storage, even if USB drives are attached to the front and rear panel ports.
• Front USB, Rear USB, RCP USB — These options force the unit to record to a
USB drive connected to the corresponding port.
NOTE: The SMP can automatically upload recording files to a network server only
for files that are recorded to and stored on the internal drive. If you select one of
the USB-only options, files cannot be auto-uploaded to a server.
3. To save recordings to two locations at once (to use secondary recording mode):
a. Select (check) the Enable Secondary Recording checkbox (
1
).
• The selection in the Recording Destination field (
2
) changes to
Internal Drive. This cannot be changed while secondary recording mode
is enabled. The recording is always stored to the internal drive.
• The Secondary Recording Destination: drop-down list (
4
) is enabled.
b. Select an option (Auto, Front USB, Rear USB, or RCP USB) from the Secondary
Recording Destination: drop-down list. This designates which connected
storage drive is used to store a second copy of the recording.
4. If desired, you can limit users to the storage drive location selected in step 2 or
the Secondary storage drives specified in step 3. Select (check) the Record
Destination Limiter checkbox (
5
).
figure 43

Extron electronics SMP 111 Specifications

General

Brand	Extron electronics
Model	SMP 111
Category	TV Tuner
Language	English