Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·541·
Variables related to general machine parameters.
CONFIGURING THE SPINDLES OF THE SYSTEM
(V.)MPG.NSPDL
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Number of spindles governed by the CNC.
(V.)MPG.SPDLNAMEn
Variable to be read via interface.
Name of logic spindle "n".
Syntax.
Replace the "n" letter with the spindle logic number.
Remarks.
The logic number of the spindles is determined by the order in which they have been defined
in the machine parameter table. The logic numbering of the spindles continues from the last
logic axis; hence, in a 5-axis system, the first spindle of the table will be logic spindle ·6· and
so on.
TIME SETTING (SYSTEM).
(V.)MPG.LOOPTIME
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
CNC cycle (loop) time in milliseconds.
(V.)MPG.PRGFREQ
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Frequency of the PLC's PRG module (in cycles).
The frequency of the module means how often (every how many CNC cycles) a full scan
of the PLC program is executed.
V=50 V1=51 V2=52 V3=53 V4=54 ... V9=59
W=60 W1=61 W2=62 W3=63 W4=64 ... W9=69
A=70 A1=71 A2=72 A3=73 A4=74 ... A9=79
B=80 B1=81 B2=82 B3=83 B4=84 ... B9=89
C=90 C1=91 C2=92 C3=93 C4=94 ... C9=99
S=100 S1=101 S2=102 S3=103 S4=104 ... S9=109
V.MPG.NSPDL
MPG.SPDLNAME2 Spindle with logic number ·2·.
V.MPG.LOOPTIME
V.MPG.PRGFREQ
To Next Page
Loading...
